LukasU

Coming back to this a bit late 😬 faced the same problem again, but could figure it out this time. So it is an error message within Watchout, so it receicves the message, the run command in the same block is executed. Problem was, that the 50ms between jump to and run command was not sufficient. Increased to 100ms it works fine now. Problem only occured when timeline was stoped/closed.

I have a strange problem with controlling watchout with companion. On some cues I get a "Target cue not found" on first send, second send works fine. Companion 3.0.1 Watchout 6.7.2 Control via production computer

Hi all, I wonder is there anyway to link content position to a certain display? Eg I have mutliple LED walls on a stage. Some content should be on a specific position on a specific LED wall. Other content should be depending on the position of the LED wall on the stage. I'm lucky to get all content in advance, so I can create the whole show in office. But in the end I'll have to position my displays regarding to the physical position of the LED walls on stage. Therefore I'll have to move my displays on site, at least for fine adjustments. So at my current level of knowledge, I then need to reposition every media cue that should be fixed to the display position. Any way to avoid that? I normally would work with virtual displays for that, but the layer order of fixed and stage content is not so defined and I have at least BKG, FILL, CUT which all can be either screen fixed or stage defined.