Search the Community
Showing results for tags 'trigger'.
Found 3 results
Hi, I need to set up Watchout to be cued from a lighting console. The console can't send a MIDI signal without expensive extra equipment, but it can send either an OSC or UDP signal. I'm very new to both of these protocols - is there a way for Watchout to hear an OSC or UDP signal and use that to trigger a cue on the main timeline? Thank you.
Hi, I'm currently working on a show where we would like the lighting board (Grand MA 1) to trigger Watchout (Production computer). The best options are Midi Show Control and Artnet. MSC to me seems perhaps better because you can recall specific cues. Something that one cannot do with Artnet. Though right now I have a couple issues with the Midi Show Control. I got it to work, even over ethernet which is great but: 1-my show killer at the moment is the RESET command. Because the RESET MSC command stops ALL timelines (Main and Aux) even when the Cue List is specified in the incoming MSC message. The Grand MA outputs RESET command when pressing the OFF key, which is used quite a bit. But when it does so it also specifies a Cue List. The problem is that Watchout doesn't care about the Cue List Parameter. In Grand MA it is very common to use multiple Executors (Controls of Sequences - Go+ - Go- - Load - OFF - etc) so one executor can be used for Lighting, one for special effects and one could be used for Watchout but if the RESTORE command doesn't listen to the Cue List it's a big problem because all executors can reset ALL timelines. Meaning your lighting sequence could RESET all Videos cues. Not good. So could Watchout listen to the cue list parameters of the RESET command? Is there a way to tell it do so in a command file I can create? Or is this something you could do in an upcoming release? Perhaps the command could Reset everything only if no cue list is specified. 2-There is no way to go into Stand By mode from the GrandMA using MSC because it does not output ALL OFF or RESTORE. But it is capable of outputting FIRE commands so maybe macro 1 and 2 could be Stand By ON & Stand By OFF or again. Or if there would be a way in Watchout to manually assign different MSC commands to action in Watchout that would be great. Then more devices could talk to Watchout because any commands be used for any action. Otherwise more options for using Artnet IN data to control watchout would be great. Ex: specific cues, next, previous, load, stand by, play, pause. Thank you. I look forward to hearing the possibilities.
Hi, I'm working on a production where they are thinking about triggering Watchout from a GrandMA 1 for their shows. They are already running a lot things on Artnet and since network is so convenient they would like to use Artnet instead of MSC. Now because they have a lot of artnet already going out on their lighting network I would rather keep that separate from the Watchout network. So is there a way to use 2 NICs on a production computer? 1 to talk to the display computers and one to monitor and send the artnet triggers to the Watchout Production software? Or Do I need a piece of software or hardware to transfer the information from one network to the other? Thank you.