Search the Community
Showing results for tags 'width & hight same as displa'.
Hi all, I just have a quick question about out putting signals and changing the display resolution. I have a show coming up where I have 6 x 1920 x 1080 projectors . Two of these projectors will be projecting onto standard 16/9 screen surfaces. The other four will be projecting onto a skinny vertical screens The resolutions of these screens are as follows: Screen Set 1 = 2 x projectors with 2 x vertical projection surfaces 480w x 1080h. Screen Set 2 = 2 x projectors with 2 x vertical projection surfaces 720w x 1080h. So my question to you is this. In watch out if I deselect the little checkbox that says "width & hight same as display resolution" I should only be seeing on that particular output the prescribed resolution above. But at the moment it appears that it is stretching to full for 1920 x 1080 and not just give me my content in the middle of the screen with black bars left and right. Am i doing this right? thanks