Jump to content
Dataton Forum
danielbrodie

ETC IOS/EON Settings for Midi Show Control (MSC)

Recommended Posts

These are the settings that we always set up in the IOS or EON family of ETC lighting desks for successful Midi Show Control (MSC) of Watchout.

 

  • SMPTE Time Code RX - Enabled
  • MIDI Time Code RX - Enabled
  • Resync Frames - 2
  • MSC Receive - Disabled (Unless you want to receive MSC from another device, but Watchout doesn't send MSC)
  • NSC Receive Channel - 0
  • ACN MIDI RX ID - 1
  • MSC Transmit - Enabled
  • MSC Transmit Channel - 0
  • ACN MIDI TX ID - 1 (Or whatever you have your device ID set to in Watchout.)
  • Analog Input - Enabled
  • Relay Output - Enabled
  • Serial Enable - Enabled
  • Serial Group ID - 1

 

A key setting to pay attention to is the TX ID. This is the device ID and it must match the device ID set in Watchout.

 

After all of this is set, you should be able to just set your Control Cues to match the numbers of the cue stack in the lighting desk, and be successfully tracking Midi Show Control.

 

Hope this is helpful.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...