Jump to content
Dataton Forum
Kasperdurr

3D mapping looses geometric correction

Recommended Posts

Hi All

We have a fixed installation at a museum. We are using Watchout 6.2 for geometric mapping onto a 3d-model in Watchout.
The setup uses 3 projectors with overlap, projecting on a physical structure. 

Usually this works fine, but more than 5 times now over 1 year, we have experienced that Watchout looses its mapping, and from that point on the mapping is not correct, and wan't be correct before we adjust again with the production software. When the mapping is offset, we tried adjusting the projectors to see if the problem could be them moving, but the mapping is offset in a way that projector adjustments would not be able to solve, and therefor not a physical problem, but more likely a software-problem. 

The installation shuts off each evening and turns on each morning. The Watchout show is startet and shut down from a control-system (Medialon).    

Does anyone have similar experiences with a fixed installation using the 3d-mapping features? 

 

Best regards Kasper

Share this post


Link to post
Share on other sites

There have been numerous bug fixes between 6.2 and 6.2.2, have you considered updating?

You indicated "... Watchout show is startet and shut down from a control-system (Medialon) ...". Can we assume that means system is operating in cluster mode (no WATCHOUT Production)?

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...