MHeuberger
-
Posts
4 -
Joined
-
Last visited
Posts posted by MHeuberger
-
-
Thank you Rainer,
we will try to run Dante at the production server. This would not be our first choice, because the production server might change during setup...
Kind regards, Martin
0 -
As the last post is from 2017 I would heat up the thread again.
Is ist still "not" possible to install Dante Virtual Card on a watchpax 60 ?
Our configuration will be 1 production Server and 3 Watchpax 60. The customer asked to do all audio output in Dante.
Kind regards, Martin
0 -
This would help our "on-the-field" workflow too.
Hi,
I do not know if it was already posted.
2 Things:
When you have your warping grid in front of you a bigger windows AND the possibility to turn on the image you are seeing would be nice. When you want to add an additional Grid Point sometimes it would be fine to see where you set the new point when doing a little more than just the "normal" panorama Projection
best regards
Thomas Diemath
0
Startup Show Production Computer & Watchpax 60
in WATCHOUT FORUM
Posted
Hi there,
I was just into the manual and some threads in this forum, but not getting closer to a solution.
We have a pemanent installation with one production pc and 3 watchpax 60. The production pc need to run the show, as we use multichannel via Dante Card for Audio-Out. On Page 192, last Topic it says that the production software accepts only the full path to a showfile to load. So none of the commands for the autostart.txt can be used, right ?
Later the Show should be started on the production pc with AMX, (which is well documented (will be right back if I stuck there)).
Kind regards, Martin