Luminal Posted September 13, 2018 Report Share Posted September 13, 2018 One of my displays is behaving strangely. The geometry changes on it’s own, then jumps back the correct geometry. It’s basically flicking between two states of geometry while the show is running - the correct one I had programmed and something completely different (but always the same each time). Any ideas on what may be causing this and some ideas to rectify? Using Watchout 5 and Watchpax 2’s. Quote Link to comment Share on other sites More sharing options...
Benoit Posted September 13, 2018 Report Share Posted September 13, 2018 Hello Luminal, I've already seen some projectors with an inclination sensor to change the trapeze depending on the position of the projector... We've removed the option in the projector menu. Good luck! Benoit Quote Link to comment Share on other sites More sharing options...
Luminal Posted September 13, 2018 Author Report Share Posted September 13, 2018 34 minutes ago, Benoit said: Hello Luminal, I've already seen some projectors with an inclination sensor to change the trapeze depending on the position of the projector... We've removed the option in the projector menu. Good luck! Benoit Thanks Benoit. The projector is rated for full 360 installation and no keystone is applied. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.