How to use output string Cue ? I want to control the Barco Project power through tcp/ip

[Gates kweon]

hi dear
I turn the projector on/off through string output
I'm going to do it.
The projector is a Barco GW60-W7.
It works fine with PJ Link.
But I wonder if this can work via production pc string ouput
I want to know.

IP address and IP Port are set correctly.
However, when applied to the timeline, it is not working.

How to write the command in String Cue Data to send
I do not know.

The on command in pj link is " send %power 1 ".

I was wondering how to apply this to Data to Send.

[jfk]

probably need a carriage return to terminate the string. i.e.

%power 1$0D

of course, production must be online to actually send the string

[Gates kweon]

thank for jfk

I did it your way.
But it's not working and I don't know why.
Because pj link port 4352
Port 4352 was used.
Do I need to do something else before running watchout production?

Edited January 21, 2022 by Gates kweon

[RBeddig]

The best strategy has always been to first test your communication and important strings from a Telnet client like PuTTY. Then of course very often a carriage return as mention by Jim is necessary.

How did you test the PJLink commands outside WATCHMAKER before?

Projectors nowadays very often use password protection. If the software you used to test PJLink before asked for a user and a password this would be a strong indication.
In this case the solution would be to disable the password protection when you want to control it from WATCHOUT.