TimoWO Posted November 17, 2016 Report Share Posted November 17, 2016 Dear All, I've got here a Show with 8 HD Outputs on a LED Wall. All Machines are synced via S400 - and the Content is in 90% sync on the wall. But it seems that when the timeline marker reaches the File - the trigger to the display computer is minimal delayed sometimes. It happens now and then wihtout any reason. When I click ten times the timeline - only 7 times the content is starting sync. This delay stays continously through the while file. I think it could be a network problem ? Does anyone had this situation before ? Thanks for fast answers . My Show will begin in 10 hours. Kind regards, Timo Quote Link to comment Share on other sites More sharing options...
Myngus Posted November 17, 2016 Report Share Posted November 17, 2016 does sound like network to me. is there anything unnecessary plugged in that you can remove from the network? change network cables? Quote Link to comment Share on other sites More sharing options...
Benoit Posted November 17, 2016 Report Share Posted November 17, 2016 Hi Timothy, Just an idea, did you try to increase the pre-roll? Instead of automatic, try 10 seconds. Regards, Benoit Quote Link to comment Share on other sites More sharing options...
caparellisergio Posted November 19, 2016 Report Share Posted November 19, 2016 8 hd outputs, thats one big led wall. Im just guessing, but i had a similar problem a few days ago, and finally the problem was with the splitted video files. They had different bit rate and sometimes they would go out of sync Quote Link to comment Share on other sites More sharing options...
Michael Darling Posted December 20, 2016 Report Share Posted December 20, 2016 I had a same issue with sync problem in LED Screen, I am using six display in two display servers and sending the output to six led processors. i am getting the delay from the two server, one server using three outputs and other three. each server had a millisecond delay. So Any solution for it? I7, 32GB, SSD, Firepro7100 8GB, Watchout version 6 Thanks in advance. Quote Link to comment Share on other sites More sharing options...
Jonas Dannert Posted December 21, 2016 Report Share Posted December 21, 2016 Just some questions Michael, since it's not mentioned: - are you sure your 6 LED-processors are synced towards each other? - you are using AMD S400 sync cards in your setup to sync the outputs of the 2 WATCHOUT Display PC's? /jonas Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.