Add Posted July 19, 2019 Author Report Share Posted July 19, 2019 morning everyone. i found a problem here and want to know something. my mctrl660 is 50hz but in amd's control panel it shows 49.9974hz does it matter? wo can't set 49.9974hz it only support to set 49.99hz or 50hz. Quote Link to comment Share on other sites More sharing options...
wiesemann Posted July 21, 2019 Report Share Posted July 21, 2019 maybe it is not Watchout but the LED Walls own system. Inwould try to feed it the exact same source from only one „player“ and check that. Quote Link to comment Share on other sites More sharing options...
RBeddig Posted July 30, 2019 Report Share Posted July 30, 2019 On 6/21/2019 at 4:33 PM, Add said: morgan tell me to install amd’s driver to 2017q4 instead of now i install version 2019q2 but i’have not test yet Have you tested driver version 2017Q4.1 yet? I've just received some information that 2019Q2 has a known bug which can lead to tearing within a display group even if you use the S400 sync board. This is planned to be fixed in the next update in 2-3 weeks. Don't know though what they might break in the update on other aspects. Quote Link to comment Share on other sites More sharing options...
thrietaxiol Posted August 11, 2019 Report Share Posted August 11, 2019 How can you scan lock different scan rates - did not think that was possible? Always thought you could only scan lock matching scan rates. Paripdf Gofrgo Quote Link to comment Share on other sites More sharing options...
Muath I J Posted August 20, 2019 Report Share Posted August 20, 2019 can you try to connect all sending cards together with a serial USB then send RCFG files in 1 shot , usually if each sending card were programmed individually you will end up with unmatching colors or some times unmatching clock . hope this helps Cheers Quote Link to comment Share on other sites More sharing options...
Dennis Essens Posted September 28, 2019 Report Share Posted September 28, 2019 Hi Guys, is this still an issue ? are you positive on running the same firmware on both led processors ? had an issue last with 8 4K processors not running in sync. updated firmware and everything runs smooth again :) Quote Link to comment Share on other sites More sharing options...
WatchDog Posted October 29, 2019 Report Share Posted October 29, 2019 https://forum.dataton.com/topic/2558-latency-on-running-cues/?do=findComment&comment=13657 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.